2.40
ENG_UD68725_4
Régulateur de vitesse (XEF - Alpine)
Returning to the cruising speed
If a speed is stored, it can be recalled,
once you are sure that the road con-
ditions are suitable (traffic, road sur-
face, weather conditions, etc.). Press
switch 3 (RES) if the vehicle speed is
above 20 mph (30 km/h).
When the stored speed is recalled, acti-
vation of the cruise control is confirmed
by the illumination of the cruising speed
in green.
NB: if the speed previously stored is
much higher than the current speed,
the vehicle will accelerate more rapidly
to reach this threshold.
CRUISE CONTROL (4/4)
Switching off the function
The cruise control function is deacti-
vated if you press switch 1: in this case
a speed is no longer stored. The green
indicator light switches off to con-
firm that the function is deactivated.
Putting the function on
standby
The function is set to standby if you:
– use the switch 4 (0);
– the brake pedal;
– the transition of the gearbox to N po-
sition.
In all three cases, the cruising speed
remains stored and this speed appears
on the instrument panel.
Standby is confirmed by the display of
the cruising speed in grey.
Putting the cruise control
on standby or switching it
off does not cause a rapid
reduction in speed: you
must brake by depressing the brake
pedal.
a
3
4
When the cruise control is set to
standby, pressing on the side a (+)
of the switch 2 reactivates the cruise
control function without taking into
account the stored speed: it is the
speed at which the vehicle is moving
that is taken into account.
1
2
To Next Page
Loading...