3.12
ENG_UD67683_3
Lève-vitres électriques / Lève-vitres impulsionnels / Lève-vitres manuels (XEF - Alpine)
ELECTRIC WINDOWS (2/2)
Operating faults
In case of a fault when closing a window,
the system reverts to normal mode:
pull the switch concerned up as often
as necessary to fully close the window
(the window will close gradually), hold
the switch (still on the closure side) for
one second then lower and raise the
window fully to reinitialise the system.
If necessary, contact your authorised
dealer.
Avoid resting any objects against
a half-open window: there is a risk
that the electric window could be
damaged.
Impossible to operate the one-touch
electric window
The one-touch electric window is
equipped with heat protection: if you
press the switch for the window more
than sixteen consecutive times it goes
into protection mode (locking the
window).
You can:
– use the electric window switch briefly
and with intervals of approximately
30 seconds;
– with the engine running, the window
will be unlocked after approximately
20 minutes of inaction on the electric
window switch.
To Next Page
Loading...