wipers
blades ..................................................
(up to the end of the DU)
wiper blades ..............................................
(up to the end of the DU)
5.30
ENG_UD54116_3
Balais d essuie-vitres : remplacement (XEF - Alpine)
Windscreen wiper (replacing the blades)
To refit
To refit the wiper blade, proceed in the
reverse order to removal. Ensure that
the blade is locked and the screen
washer fluid pipe is connected properly.
Replacing windscreen wiper
blades 1
Do not raise the window wiper arm 4.
– Lower the windscreen wiper stalk
fully: the wiper blades will stop
slightly away from the bonnet;
– with the ignition off, press tab 2 on
blade 1;
– pull the blade towards you to release
it;
– disconnect the windscreen washer
fluid pipe 3.
WIPER BLADES: replacement
1
Check the condition of the wiper
blades. You are responsible for their
service life:
– clean the blades and the wind-
screen regularly with soap and
water;
– do not use them when the wind-
screen is dry;
– free them from the windscreen
when they have not been used
for a long time.
– In frosty weather, make
sure that the wiper blades
are not stuck by ice (to
avoid the risk of the motor
overheating).
– Check the condition of the wiper
blades.
Replace the wiper blades as
soon as their performance starts
to diminish (approximately once
a year).
Whilst changing the blade, take care
not to drop the arm onto the window
after it has been removed as this
may break the window.
4
3
2
As the windscreen wiper
blades 1 are specific to
the windscreen, they must
be replaced with equivalent
windscreen wiper blades.
Consult an approved dealer.
To Next Page
Loading...