5.32
ENG_UD67694_4
Remorquage : dépannage (XEF - Alpine)
TOWING: breakdown recovery (2/2)
When the engine is stopped,
steering and braking assist-
ance are not operational.
Do not leave the tools unse-
cured inside the vehicle as
they may come loose under
braking.
– Use a rigid tow bar.
– A vehicle must not be
towed if it is not fit to be
driven.
– Avoid accelerating or braking
suddenly when towing, as this
may result in damage being
caused to the vehicle.
– In all cases, it is advisable not to
exceed 16 mph (25 km/h).
Only use the front towing point 2.
(never use the drive shafts or any other
part of the vehicle).
This towing point may only be used for
pulling. It must never be used for lifting
the vehicle directly or indirectly.
Access to the towing point
Press zone A and keep depressed
while pulling zone B to open flap 4.
Screw in the towing eye 3 fully: as far
as possible by hand at first, then finish
by tightening it using the wheelbrace.
Use the towing eye 3 only (please see
“Tools” in Section 5).
B
A
2
3
4
Ensure that the towing eye
is bolted correctly.
Risk of losing the towed
object.
To Next Page
Loading...