1.58
ENG_UD60078_2
Ordinateur de bord : paramètres de voyage (XEF - Alpine)
The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT AND COUNTRY.
TRIP COMPUTER: journey parameters (4/5)
Examples of selections
Interpreting the display selected
On-board computer with mileage-
before-service message
g) Mileage before service or oil change.
Mileage before service
With the ignition switched on and the engine not running,
when the message “SERVICE INTERVALS” is displayed, press
button 2 or 3 for around 5 seconds to display the mileage before
the next service, then briefly press button 2 or 3 to view the
mileage before the next oil change (distance or time remaining
before the next service). When the distance value approaches its
limit, there are several possible scenarios:
– range less than 930 miles (1,500 km) or one month: the
message “Service due” is displayed accompanied by the
nearest term (distance or time);
– range equal to 0 miles (0 km) or date of oil change reached:
the message “Service required” is displayed accompanied by
the warning light
©.
The vehicle requires an oil change as soon as possible.
SERVICE
INTERVALS
Oil change in
15 000 km / 24 months
Service due in
300 km / 24 days
Service required
Depending on the vehicle, the distance required before an oil change is required varies according to the driving style (frequent
driving at low speeds, door-to-door journeys, extensive use at idle speed, etc.). The distance remaining until the next oil change
can therefore decrease more quickly in some cases than the actual distance travelled.
Reset: to reset the distance before service, press and hold 3, 4 or 5 for approximately 10 seconds until the display shows the
mileage permanently.
NB: if a service is performed without changing the engine oil, only the mileage before the next service should be reset. In the
event of an oil change, both the distance before the next service and the next oil change should be reset.
To Next Page
Loading...