5-EN
Adjusting Volume/Balance
(
Between
Left and Right
)
/Fader
(
Between Front
and Rear
)
/Defeat
1 Press the MODE (Rotary encoder) button repeatedly
to choose the desired mode.
Each press changes the modes as follows:
Volume :0~35
Balance :L15~R15
Fader :R15~F15
Subwoofer :0~+15
NOTES
• If the Rotary encoder is not turned in 5 seconds after
selecting the BALANCE, FADER, DEFEAT and
SUBWOOFER modes, the unit automatically sets in the
VOLUME mode.
•∗ When the subwoofer is set to OFF, the level of the subwoofer
cannot be adjusted.
2 Turn the Rotary encoder until the desired sound is
obtained in each mode.
By setting Defeat ON, previously adjusted setting of
Bass, Treble will return to the factory defaults, but MX
will be turned off.
Blackout Mode On and Off
(
CDA-7894RB only
)
When the Blackout mode is turned on, the display will
turn off to reduce power consumption.
This additional power enhances the sound quality.
1 Press and hold the B.OUT button for at least 3
seconds to start the blackout mode. By doing so the
display will turn off.
NOTE
If any button on the unit is pressed during the blackout mode,
the function will be displayed for 5 seconds to show the
operation before returning to Blackout mode.
To cancel the blackout mode, press and hold the
B.OUT button for at least 3 seconds.
Changing the Audio Level Display
Pattern
You can select the display pattern mode from three
display patterns. You can also deactivate the display.
1 Press the DISP (DISPLAY) button to select the desired
Display pattern mode.
Each press changes the display patterns.
Movable display
Turning Power On and Off
1 Press the POWER button to turn on the unit.
NOTE
The unit can be turned on by pressing any other button except
the eject c button.
The volume level gradually increases to the previous
level you were listening to before the unit was turned
off.
Press and hold the POWER button again for at least 3
seconds.
NOTE
The very first time the power is turned on, the volume will start
from level 12.
Display Angle Adjustment
The movable display may be adjusted to 3 different
angles depending upon user preference.
1 Press the ANGLE 89 button to adjust the angle of the
movable display.
NOTES
• The display will close a half minute after the ignition key is
turned to the OFF position.
• The adjusted angle of the display is stored in memory. There
is no need to re-adjust the angle when the power is turned
back on.
CAUTION
Keep hands (or any other object) away from the display while
it is opening or closing to avoid damage or injury. The back of
the movable display will get very warm under normal
operating conditions. This is not a malfunction. Do not touch.
→ Volume → Subwoofer
∗
→ Balance → Fader → Defeat
→ Pattern1 → Pattern2 → Pattern3 → Display OFF
To Next Page
Loading...
Need help?
General
