53-EN
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries
various noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
Parking Brake Lead Connection
If necessary, use a pinch connector to connect the parking brake lead, etc.
Connection Diagram of SPST Switch (Sold Separately)
(If the ACC power supply is not available)
1
Vehicle Cable
Stopper
Monitor Cable
Pinch Connector
2
Pliers
Battery
(Red)
SPST SW (Optional)
(Yellow)
Installation and Connections
CVA-1004R
FUSE (5A)
(Optional)
FUSE (10A)
(Optional)
• If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold separately).
• The diagram and the fuse amperage shown above are in the case when CVA-1004R is used individually.
• If the switched power (ignition) lead of the CVA-1004R is connected directly to the positive (+) post of the vehicle‘s battery, the CVA-1004R
draws some current (several hundred milliamperes) even when its switch is placed in the OFF position and the battery may be discharged.
ACC
BATTERY
To Next Page
Loading...
