Alpine D-AUDIO - Sound Setup; Simple Sound Settings; Setting the Fader;Balance; Adjusting the Bass;Middle;Treble

13-EN
[Sound] is selected on the Setup menu screen.
You can set up items related to the sound quality.
Touch [Advanced] or [Simple] to change the setting screen.
<Setting item>
* Touch [] or [] to show further hierarchies.
Simple Sound Settings
[Simple] is selected on the Sound Setup menu screen.
Setting item:
Fad./Bal., Bass/Treble, EQ, Sub.W
Cancel
Sound setup finishes.
Fader/Balance Image area
Touch the desired point within the image area, or touch [ ],
[], [] or [].
Fader:
[10]Front to [10]Rear
Balance:
[10]Left to [10]Right
• To reset to the initial setting (Fader: F=R, Balance: L=R), touch [ ].
Touch [ ] or [ ] for each item to be adjusted.
Setting item:
Bass, Middle, Treble
Setting contents:
-7 to 7 (Initial setting: 0)
• To reset the initial setting (Bass: 0, Middle: 0, Treble: 0), touch [Flat].
• When the Defeat setting is [On], you cannot perform the set up.
5 typical equalizer settings are preset at the factory for a variety of
musical source material. You can also preset an equalizer by
customizing.
Setting item:
EQ
Setting contents:
Flat (Initial setting), Jazz, Rock, Classical, Pop, Custom
• When the Defeat setting is [On], you cannot perform the set up.
• Only one type can be set.
•When you select [Custom], the P-EQ setting screen is diaplayed
(page 15).
• If you select a content except for [Custom] on this setting, P-EQ setting
(page 15) cannot be reflected.
Sound Setup
Simple
Fad./Bal. (page 13)
Bass/Treble (page 13)
EQ (page 13)
Sub.W (page 14)
Advanced*
X-Over (page 14)
P-EQ (page 15)
TCR (page 15)
MX (page 16)
Defeat (page 16)
Setting the Fader/Balance
Adjusting the Bass/Middle/Treble
Setting an Equalizer