Operating Instructions of Mobile Phone APP
4
After the PXE-0850X APP has been successfully
installed on the mobile phone, the PXE-0850X machine
will be started. Open mobile phone “Settings”→
“Enabling Bluetooth”→ “Searching Device”→ “DSP-
HD-...”, click connection, or directly open the PXE-
0850X APP to automatically search Bluetooth, click to
connect “DSP-HD-...”, which will indicate successful
connection after displaying 100% data synchronization.
Read the disclaimer carefully and click “Accept”
to enter the homepage interface.
Interface Introduction
There are five interfaces with different functions,
including delay, channel, homepage, EQ and frequency
combination. Enter the homepage interface by default.
Homepage Interface
Machine Connection
If the Bluetooth icon shows red
【 】
, the Bluetooth
of the mobile phone is not connected; and if the
Bluetooth icon shows green
【 】
, the Bluetooth of the
mobile phone is connected.
Menu Bar Introduction
Click the menu bar
【 】
at the upper right corner
to enter “Encrypt”, “Share Sound Effect”, “Save Sound
Effect”, "Local Sound Effect" and “About” operations.
1. Select “Encrypt” to enter a 6-digit encrypted
password to encrypt the already tuned sound
effect data. Click “Decrypt” to enter the correct
password to decrypt the already encrypted data;
and on the decryption interface, click “Clear Data”
to remove by one key the encryption state and
restore the data to the ex-factory state.
2. Select “Share Sound Effect”to choose single
group sharing or whole machine sharing.
3. Select “Save Sound Effect” to input the file
name and remarks, and you can choose single
group or whole machine saving.
4 Select “Local Sound Effect”to call sound effect
files saved in the mobile phone.
5. Select “About” to view the device version.
Sound Source Selection
1. Main sound source: click the button below the
main sound source, and select the main sound
source: digital, high level, Bluetooth or low
level in the pop-up window.
2. Auxiliary sound source (audio mixing):
a. Click the button below the auxiliary sound
source, and select the auxiliary sound
source: digital, high level, Bluetooth,low
level or turn off in the pop-up window.
b. The greater the attenuation of the main
sound source is, the lower the main volume
is. The adjustable values are 0%, 30%, 50%,
80% or 100%, and the default value is 0%.
* The auxiliary sound source cannot be
superimposed with the current input sound
source, otherwise the auxiliary
sound source
will be invalid.
Master Volume Setting
The master volume can be adjusted by dragging the
fader or clicking “+” or “-”button. The adjusting range
is: 0-35, and the default value is 27. Click the master
volume horn button
【 】
to set the master volume to
mute
【 】
, and click again to cancel mute (the mute
will be automatically canceled when the master volume
is adjusted).
To Next Page
Loading...
