4
ASSEMBLING & USING YOUR PRODUCT
Unpack all components carefully. Check the packaging to ensure that
you have removed all of the parts. Some splashing may occur when
the fountain is in use.
1. Place the fountain base on a smooth and level surface. Allow
enough space to access the pump through the back door.
2. Remove the pump from its packaging and adjust the ow control
to the lowest setting to avoid splashing until the fountain is
completely assembled.
3. Pull the vinyl tubing through the back opening of the fountain and
connect it to the pump using the black tube connector.
Alpine Quick Tip #2
The tube connector may be
attached to the vinyl tubing or
to the pump depending on the
product. It is shown attached
to the pump here.
Tube Connector
Alpine Quick Tip #1
Turn counter-clockwise to reduce
the water ow. Turn clockwise to
increase the water ow.
To Next Page
Loading...
