5
ASSEMBLING & USING YOUR PRODUCT
4. Place the pump with the suction feet facing down on the bottom of
the reservoir inside the fountain.
5. Pull the LED light/speaker cord from the back of the fountain and
connect it to the transformer. Slide the protective cover over the
connection and turn clockwise to securely tighten.
6. Without splashing, gently pour water into the fountain. Using
distilled water prevents scale build-up. Do not allow the water to
overow! Make sure the water completely covers the pump.
7. Plug the transformer and the plug from the pump into your local
power supply. The pump with turn on and the fountain will begin to
run.
Alpine Quick Tip #3
Make sure that there is no water
around the plugs and always keep the
power source in a dry place. Plug the
power cords into a properly grounded
GFCI outlet when using outdoors.
To Next Page
Loading...
