Alstom MiCOM P54 Series - Page 146

P54x/EN ST/La4 Settings
(ST) 4-68 MiCOM P543, P544, P545, P546
ST
Setting range
Menu text Default setting
Min. Max.
Step size
Relay Address 1 255 0 255 1
Sets the first rear port re ress. lay add
Plant Status 0000000000000010
Displays the circuit brea nt status. ker pla
Control Status 0000000000000000
Not used.
Active Group 1 1 4 1
Displays the active setti p. ngs grou
CB Trip/Close No Operation No Operation/ Trip/Close
Supports trip and close mands if enabled in rcuit Bre ntrol mcom the Ci aker Co enu.
Software Ref. 1 P54x____1__055_K
Software Ref. 2 P54x____1__055_K
Displays the relay software version including protocol and relay model.
Software Ref. 2 is displayed for relay with IEC 61850 protocol only and this will display the
software version of the Ethernet card.
Opto I/P Status 000000000000000000 000000000000 00
Display the status of the available opto inputs fitted.
Relay O/P Status 00000000000000000000000000000000
Displays the status of all available output relays fitted.
Alarm Status 1 00000000000000000000000000000000
32 bit field gives status of first 32 alarms. Includes fixed and user settable alarms.
Alarm Status 2 00000000000000000000000000000000
Next 32 alarm status defined.
Access Level 2
Displays the current access level.
Level 0 - No passwor - Read a rms, event records
sword 1 d - As leve ds, e.g. circuit
Clearing of event and fault records
- Password 2 - As leve s
d required ccess to all settings, ala
and fault records
Level 1 - Pas or 2 require l 0 plus: Control comman
breaker open/close
Reset of fault and alarm conditions, Reset LEDs
Level 2 required l 1 plus: All other setting
Password Control 2 1
Sets the menu access level for the relay. This setting can only be changed when level 2
access is enabled.
Password Level 1 ****
Allows user to change p assword level 1.
Password Level 2 ****
Allows user to change password level 2.