Alstom MiCOM P54 Series - 1.10 MiCOM S1 Studio relay communications basics; 1.10.1 PC requirements; 1.10.2 Connecting to the P54 x relay using MiCOM S1 Studio

Getting Started P54x/EN GS/La4
MiCOM P543, P544, P545 & P546 (GS) 3-17
GS
1.10 MiCOM S1 Studio relay communications basics
The EIA(RS)232 front communication port is intended for use with the relay settings program
MiCOM S1 Studio. This program runs on Windows
TM
2000, XP or Vista, and is the universal
MiCOM relay Support Software used for direct access to all stored data in any MiCOM relay.
MiCOM S1 Studio provides full access to
:
 MiCOM Px40, Modulex series, K series, L series relays
 MiCOM Mx20 measurements units
1.10.1 PC requirements
To run Mi
COM S1 Studio on a PC, the following requirements are advised.
Minimum
 1 GHz processor
 256 MB RAM
 Windows
TM
2000
 Resolution 800 x 600 x 256 colors
 1 GB free hard disk space
Recommended
 2 GHz processor
 1 GB RAM
 Windows
TM
XP
 Resolution 1024 x 768
 5 GB free hard disk space
Microsoft Windows
TM
Vista
 2 GHz processor
 1 GB RAM
 5 GB free hard disk space
 MiCOM S1 Studio must be started with Administrator rights
1.10.2 Connecting to the P54x relay using MiCOM S1 Studio
This
section is intended as a quick start guide to using MiCOM S1 Studio and assumes you
have a copy installed on your PC. See the MiCOM S1 Studio program online help for
more detailed information
.
1. Make sure the EIA(RS)232 serial cable is properly connected between the port on the
front panel of the relay and the PC. See section 1.9.
2.
To start Micom S1 Studio, select Programs > MiCOM S1 Studio > MiCOM S1 Studio.
3. Click the Quick Connect tab and select Create a New System.
4. Check the Path to System file is correct, then enter the name of the system in the Name
field. If you need to add a brief description of the system, use the Comment field.
5. Click OK.