P54x/EN ST/La4 Settings
(ST) 4-82
MiCOM P543, P544, P545, P546
ST
1.4.7.4 Communications settings for Ethernet port – IEC 61860
ngSetting ra e
Menu text Default setting
Min. Max.
Step size
NIC Protocol
IEC 61850
Indicates that IEC 61850 will be used on the rear Ethernet port.
NIC MAC Address
Ethernet MAC Address
Indicates the MAC addre et port. ss of the rear Ethern
NIC Tunl Timeout 5 mins
1 min 30 mins 1 min
Duration of time waited before an inactive tunnel to MiCOM S1 Studio is reset.
NIC Link Report Alarm
Alarm, Event, None
Configures how a failed/unfitted network link (co r or fiber) is reppe ported:
Alarm - an alarm is raised for a failed link
Event - an event is logged for a failed link
None - nothing reported for a failed link
NIC Link Timeout 60 s 0.1 s 60 s 0.1 s
Duration of time waited, after failed network link is detected, before communication by the
alternative media interfa ce is attempted.
See also the IED CONFIG OR column for IEC 61850 data. URAT
1.4.7.5 Communications settings for Ethernet port – DNP3.0
Setting range
Menu text ult setting e e Defa
Min. Max.
St p siz
NIC Protocol
DNP3.0
Indicates that DNP 3.0 used on the rear Ethernet port. will be
IP Address
0.0.0.0
Indicates the IP addres y s of the rela
Subnet Mask
0.0.0.0
Indicates the Subnet address
NIC MAC Address
Ethernet MAC Address
Indicates the MAC addr ear Etherneess of the r t port.
Gateway
Indicates the Gateway a ss ddre
DNP Time Sync. Disabled Disabled or Enabled
If set to ‘Enabled’ the DNP3.0 master station can be used to synchronize the time on
the relay. If set to ‘Disabled’ either the internal free running clock, or IRIG-B input are
used.
NIC Tunl Timeout 5 mins
1 min 30 mins 1 min
Duration of time waited before an inactive tunnel to MiCOM S1 Studio is reset.
To Next Page
Loading...
