Section 7 — Maintenance • 37
Section 7 — Maintenance
This unit is the result of Altec’s advanced technology and
quality awareness in design, engineering, and manufac-
turing. At the time of delivery from the factory, this unit met
or exceeded all applicable requirements of the American
National Standards Institute. All information, illustrations,
and specications contained within this manual are based
on the latest product information available at the time of
publication. It is essential that all personnel involved in
the use and/or care of this unit read and understand the
Operator’s section of this manual.
Given reasonable care and operation, according to the
guidelines set forth in the manuals provided, this unit will
provide many years of excellent service before requiring
major maintenance.
The scope of this manual is limited to periodic mainte-
nance. It does not cover methods that may be required
to inspect and repair major damage to the unit. Impacts
to and excessive forces on the unit, through vehicular
accidents, rollovers, excessive loading, and the like, may
result in structural damage not obvious during a visual
inspection. If the unit is subjected to such impacts or forces,
a qualied person may need to perform additional testing
such as magnaux or ultrasonic testing as applicable. If
structural damage is suspected or found, contact Altec
for additional instructions.
Warning
Death or serious injury can result from component
failure. Continued use of the unit with hidden damage
could lead to component failure.
Never alter or modify this unit in any way that might af-
fect the structural integrity or operational characteristics
without the specic written approval of Altec Industries,
Inc. Unauthorized alterations or modications will void
the warranty. Of greater concern, is the possibility that
unauthorized modication could adversely affect the safe
operation of this unit, resulting in personal injury and/or
property damage.
Set-up requirements, work procedures, and safety precau-
tions for each particular situation are the responsibility of
the personnel involved in the use and/or care of this unit.
Danger
Death or serious injury can result when performing
maintenance on the unit.
Maintenance personnel must be trained in safe ser-
vice procedures.
Proper unit maintenance will reduce downtime, lower
operating and repair costs, and extend equipment life.
Safety alone justies a preventive maintenance program.
This type of program is less expensive than making
major repairs.
This section contains information on properly inspecting
the hydraulic system, structures, individual unit compo-
nents, and lubrication.
Checklists are provided in the Appendix. Use these
checklists when performing routine maintenance and
inspections to make sure no areas are overlooked. Keep
permanent, written, and dated records of all service
performed on the unit.
More frequent maintenance may be necessary if the unit
is operated under severe conditions.
It is essential that all personnel involved in the care of
this unit read and understand the manual. Safety alerts
throughout the manual highlights situations in which ac-
cidents can occur. Give special attention to all safety alerts.
The safety information in this section applies only to the
maintenance of this unit. Although procedures have been
written to protect the mechanic and other personnel,
there is no safety system to account for human error or
negligence.
Warning
Death or serious injury can result from careless
or improper use of the unit. The mechanic bears
ultimate responsibility for following all regulations
and safety rules of their employer and/or any state
or federal law.
Work practices may expose maintenance personnel to
hazardous materials. Before using any chemical, read
and understand the manufacturer’s label and the mate-
rial safety data sheet (MSDS). These sheets explain
emergency and rst aid procedures and waste disposal
methods. Properly dispose of oil and hazardous materials.
Caution
Injury can result from slipping and falling. Use care
and suitable work platforms during maintenance.
Maintenance procedures may require the use of ladders,
platforms, scaffolding, etc., to access the unit. Provide
suitable work surfaces clear of obstructions for mainte-
nance procedures. Do not stand or walk on surfaces that
are not intended as such.
To Next Page
Loading...