Cyclone V GX Starter Kit
User Manual
2. Plug in an USB cable from PC USB port to the USB to UART port on Cyclone V GX Starter
board.
3. The UART settings are provided below in case a connection from the PC is used. Figure 2-10
shows the screen shot of UART configuration in Putty utility.
Baud Rate: 115200
Parity Check Bit: None
Data Bits: 8
Stop Bits: 1
Flow Control (CTS/RTS): OFF
4. To begin the communication, enter specific letters followed by clicking Send. During the
communication process, observe the status of the Receive terminal window to verify its operation.
Figure 2-9 UART to USB Serial Communication
To Next Page
Loading...
