24
malletKAT Quick Start Guide
That could do it!
On the malletKAT, if you turn it off and then back on again too quickly, the sound card does
not have enough time to reset itself, and the result is no sounds. The cure...simply shut off
the instrument and wait 10 seconds. Turn it back on and viola!
The third reason might be because you are in Factory Kits, not User Kits. Make sure that
you see a “U” as the very first character on the display. If you see an F, then you need to
get back to User Kits.
Step on the Edit Footswitch.
While it is held down, tap on the BANK SELECT PAD (e natural, third from top). Now tap on
the INC (D#) or DEC (C#) several times until you see USER Kits have been selected. Let go
of the footswitch. That should take care of it.
RESET THE MALLETKAT
Performing a REINITIALIZE
Resetting the malletKAT back to the factory defaults is easy.
Step on the Edit Footswitch.
While held down press on BOTH the Forward and Backward pads at the same time. (the
little pads on the far right of the instrument).
Look at the display, the malletKAT will ask you to also press on the A# pad, next to the
backwards pad.
When all three pads are held down, the malletKAT warns you about the reset, then it sends
out a series of beeps and the instrument is reset.
The malletKAT defaults back to Factory Kits. You need to use the USER Kits for the internal
sound card. To do that...
Step on the Edit Footswitch.
While it is held down, tap on the BANK SELECT PAD (e natural, third from top). Now tap on
the INC (D#) or DEC (C#) several times until you see USER Kits have been selected. Let go
of the Footswitch.
To Next Page
Loading...
