31
malletKAT Quick Start Guide
PITCH BEND
The malletKAT has the ability to bend notes using the sustain two Footswitch. There are
several things you need to set up to get this to happen.
Controller one and Controller Two must be on the same MIDI Channel
Controller Two’s Gate Time should be set to a low value, say 100mS
When editing Controller TWO, tap on the MONO pad (the 2nd f natural) FOUR TIMES.
You will see the word PTW. Let Go.
Now you are ready. This is what you have to do.
Play a note and hold down the sustain pedal so that the note is sounding.
While the note is playing, step on the sustain 2 pedal.
Now tap a pad on the malletKAT. You will notice the pitch bend. When you release the sus-
tain two Footswitch, the bend goes back to normal.
Practice this gesture and you will get the hang of bending notes.
The white keys act like a big pitch wheel (the first three octaves).
To Next Page
Loading...
