29
malletKAT Quick Start Guide
Now move the cursor over to the STEP by using the Forward pad. Make sure that you are
on step 01. If not, use the INC or DEC to get it there.
Now move the cursor again (forward pad) until it goes to the second line. The screen says
SETUP. Change the value to 1. (our example)
Now you need to move the cursor back to STEP (use the backward pad). Now change the
STEP to 2 using the INC.
Now more the cursor back to the second line, “SETUP”. Now change the value to 5 (our
example).
Are you getting the idea?
When you finally finish, you will have
Chain 01 Step 1 =1
Chain 01 Step 2= 5
Chain 01 Step 3 = 10
Chain 01 Step 4 = 15
If you want to Loop this Chain, Go to Step 5. When you get to the SETUP number, go past
127. Now you will see that you have other choices where you can Loop the Chain, or Go to
the Next Chain.
When you are finished, move the cursor down to the last line and ENABLE Chain mode
Let go of the Footswitch. Notice that you are now in Chain 01 in Play mode. Use the For-
ward or Backward pads to toggle through these setups.
Last thing. How do you go to a different CHAIN? Step on the Edit Footswitch, hold it down
and tap on the Global pad again (d natural). Now when you tap on the INC or DEC pads, you
will see the various CHAINS that you can call up.
To Next Page
Loading...
