COMBITHERM® GAS INSTALLATION
COMBITHERM GAS INSTALLATION AND MAINTENANCE MANUAL — 6470ML
PG. 1
1.1 RECEIVING & TRANSPORTATION
Upon receipt of the Combitherm combination oven/ steamer,
check the exterior of the shipping carton for any physical
damage that could result in damage to the contents. If the
oven was not received from the carrier in an upright position,
there is a stronger possibility of concealed damage. Remove
the carton or uncrate the unit carefully and inspect for any
transit damage. Immediately report any damage to the
delivering freight carrier.
The oven must remain on the pallet while
being moved to the installation site by fork
lift or pallet lift truck
.
Note the
dimensions
required for
doorways
and aisles
for access of
the oven and
pallet to the
installation
site.Transport the oven in an upright and level position
only. Do not tilt the oven.
With the oven on the original
pallet, remove the carton and all
packaging materials. Open the
oven door and remove all
documents and other materials
from the oven interior. Remove
the roll-in cart if so equipped.
PALLETIZED DIMENSIONS
1.2 BASIC INSTALLATION SITE REQUIREMENTS
HOOD INSTALLATION IS REQUIRED
• Installation surface must be level.
• Do not install adjacent to flammable surfaces.
• Deep fat fryers or similar heat producing equipment must not be installed in
the immediate vicinity of the hand shower.
• The installation surface
must be non-combustible (unable to burn).
The oven must remain on the pallet while being moved
to the installation site with fork lift or pallet lift truck.
To Next Page
Loading...
Need help?
General
