Why is the oil cloudy in my Altrad Construction Equipment?
If the oil in your Altrad Construction Equipment appears cloudy, it's likely due to water entering through the oil filter plug. Rinse the pump out and replace the oil.
Why is there an unusual noise coming from my Altrad Tools?
If you notice unusual noise or operation of the Altrad Tools tube, check the drive end connection and re-connect if necessary. Also, examine the pull handle connection and re-connect if needed. Finally, ensure that the sectional tubes are correctly connected and re-connect them properly if they are not.
How to fix Altrad Tools tube not rotating?
If the Altrad Tools tube isn't rotating, first ensure it's properly connected to a power source. If it is, check the sectional tubes to make sure they are correctly connected; if not, reconnect them correctly.
What to do if Altrad Tools sectional tube keeps coming apart?
If the sectional tube of your Altrad Tools keeps coming apart, the cause may be damaged or incorrectly tensioned dowel pins. You should check the dowel pins and replace them as necessary.
Why is concrete sticking to the striker tube of my Altrad Tools?
If concrete is sticking to the striker tube of your Altrad Tools, the concrete may be too dry. Wet the concrete to resolve this issue.
Introduction to the manual's purpose and scope.
To Next Page
General
