Altronics CD200 - 11.0 CD200 Unit LED Diagnostic Blink Codes; 11.1 Blink Codes Overview; 11.2 LED Signals Engine Stopped; 11.3 LED Signals Engine Cranking

www.altronicinc.com
13
ALTRONIC CD200 IGNITION SYSTEM
10.41 COLD BOOT LOG:
Indicates the number of times the input DC voltage has been
cycled to zero.
10.42 WARM BOOT LOG:
Indicates the number of times the microprocessor has restarted
without a complete loss of power.
10.43 GRAPHIC DISPLAY:
The CD200 Terminal Software provides a real time graphic display
of the secondary diagnostic numbers, global engine timing
(y-axis/10) and engine speed (y-axis x 10).
11.0 CD200 UNIT LED DIAGNOSTIC BLINK CODES
11.1 CD200 IGNITION BLINK CODES:
 WhenevertheLEDDiagsstatusagisenabled(blue)byusingthe
CD200TerminalSoftware,theblinkingpatternoftheLEDonthe
side of the CD200 case can be used to interpret the general status
of the CD200 diagnostics without the use of the Terminal Software.
Withineachgroupofconditionsdescribedbelow,thepossibledi-
agnostic states are listed according to their number of blinks. The
LEDisONforabout2secondsbetweeneachblinksequenceand
the blinks occur evenly spaced at a faster rate.
11.2 LED SIGNALS WITH THE ENGINE STOPPED:
ON – STEADY = READY (NEW POWER UP OR LAST START ATTEMPT ABORTED)
ON – 1 BLINK – ON = FIRED LAST TIME ROTATING (STOPPED DUE TO STALL)
ON – 2 BLINK – ON = SHUTDOWN (BY GROUNDING G-LEAD WHEN RUNNING)
ON – 3 BLINK – ON = SHUTDOWN (BY REMOTE SERIAL REqUEST WHEN RUNNING)
ON – 4 BLINK – ON = SHUTDOWN (BY OVERSPEED WHEN RUNNING)
ON – 5 BLINK – ON = WRONG DISK PATTERN
ON – 6 BLINK – ON = LOW SUPPLY VOLTAGE (BELOW THRESHOLD WHEN RUNNING)
11.3 LED SIGNALS WITH ENGINE CRANKING:
Rotating, and still below running RPM.
ON/OFF/ON/OFF = PURGING (off first input pulse, toggles each revolution of purge)
ON – STEADY = FIRING NORMALLY (RPM below running set point value)
OFF = WRONG DISC PATTERN DETECTED
11.4 LED SIGNALS WITH ENGINE RUNNING:
 Whenring,andaboverunspeed.
ON – STEADY = FIRING NORMALLY (NO DIAGNOSTICS TO REPORT)
ON – 1 BLINK – ON = OPEN SECONDARY ALARM
ON – 2 BLINK – ON = PRIMARY SHORT ALARM
ON – 3 BLINK – ON = PRIMARY OPEN ALARM
ON – 4 BLINK – ON = NO CHARGE ALARM
ON – 6 BLINK – ON = LOW SUPPLY VOLTAGE