Altronics CD200 User Manual

FORM CD200 II 5-07
10
INSTALLATION INSTRUCTIONS
10.0 PC TERMINAL DISPLAY FUNCTIONS
10.1 ENGINE SPEED:
Indicates current speed of the engine in RPM based on disc signal.
10.2 SPARK TIMING:
Indicates the global spark timing of the engine in degrees before
TDC.ThisnumberistheLINEUPANGLEsettinglesstheTOTAL
RETARD.Slightdifferences between thisnumberandthetiming
readingobtainedwithatiminglightmayoccursincetheLINEUP
ANGLEenteredmaydifferslightlyfromtheactualangularposition
of the engine when the input pulse event is received by the CD200.
In this event, the Spark Timing number should be made to agree
withthetiminglightbychangingtheLINEUPANGLEentry.
10.3 SWITCH POSITION:
Indicates the current position of the manual timing switch on the
CD200 case.
10.4 LOOP INPUT:
Indicates the value of the external input current loop.
10.5 OBSERVED DISC:
Indicates the number of input events (timing holes or protrusions)
being recognized by the CD200 unit on the timing disc input signal
at this time.
10.6 INSERTION RETARD:
Indicates the amount of electronic insertion retard at this time.
10.7 SWITCH RETARD:
Indicates the amount of timing retard being added by the current
timing switch position at this time.
10.8 LOOP RETARD:
Indicates the actual amount of timing retard added from the cur-
rent loop versus retard lookup table curve at this time.
10.9 RPM RETARD:
Indicates the actual amount of timing retard being added by the
RPM versus retard lookup table curve at this time.
10.10 TOTAL RETARD:
Indicates the total global timing retard at this time. This number is
the sum of the Insertion Retard, Switch Retard, Loop Retard and
RPM Retard.
10.11 COUNTER:
Indicates the number of disc rotations (engine cycles) registered
since the engine was last started.

Altronics CD200 Specifications

General

Brand	Altronics
Model	CD200
Category	Control Unit
Language	English