ALTUS AL40L 4950 4B - Detailed Channel Settings; LNB and Satellite Configuration

Television / User Manual
45 / 57 TR
LNB Settings
1 Press »MENU« to open the menu.
2 Press »
<
« or »
>
« to select the »CHANNEL«
menu and press »OK« to confirm.
– »CHANNEL« menu is now enabled.
3 Select »Dish Antenna Setup« using »
V « or
»
Λ « and confirm with »OK«.
– »Dish Antenna Setup« menu will be
displayed.
4 Select the required items with »
V «, » Λ «,
»
<
«, »
>
« or »OK«.
Satellite
Select the satellite from which you want to
receive digital stations from the list with »
V «
or »
Λ « and confirm with »OK«.
Transponder
Press »GUIDE« to switch to the transponder
list. You can select a transponder from the
list, change or delete the current transpon-
der or add a new transponder.
LNB Type
Select the LNB type with »
V « or » Λ « and
confirm with »OK«.
Note:
7
Select 09750/10600 from the list if you
use universal LNB.
LNB Power
Select the LNB power as »Off« or as
»13/18V«, »13V«, »18V« according to the
LNB type with »
<
« or »
>
«.
DiSEqC 1.0
DiSEqC 1.0 switch allows for receiving from
maximum 4 satellites at the same time.
In »LNB selection«, select »LNB1«, »LNB2«,
»LNB3« or »LNB4« for the satellite that cor-
responds to the relevant DiSEqC positions
with »
<
« or »
>
«.
DETAILED CHANNEL SETTINGS
----------------------------------------------------
DiSEqC 1.1
DiSEqC 1.1 switch allows for receiving from
maximum sixteen satellites at the same time.
In »LNB Selection«, make selections be-
tween »LNB1« and »LNB16« for the satellite
that corresponds to the relevant DiSEqC
position with »
<
« or »
>
«.
Motor
Your television supports DiSEqC 1.2 motor-
ized satellite systems. This feature allows to
control the satellite through your television.
In »Motor«, make the selections for the
relevant motorized satellite system selections
with »
<
« or »
>
«.
Note:
7
Information about motorized satellite an-
tenna settings are given under the title "Mo-
torized Antenna Settings (DiSEqC 1.2)".
5 Press »EXIT« to end setting.