ALTUS AL40L 4950 4B - Time Settings; Time and Auto Standby Configuration

34 / 57 TR
Television / User Manual
TIME SETTINGS
--------------------------------------------------------------------------------------------------
1 Press »MENU« to open the menu.
2 Select the »TIME« menu using »
<
« or »
>
«
and confirm your selection with »OK«.
– The »TIME« menu is now enabled.
Move
TIME
Back Select Exit
Time 13/April 13:18
Time Zone GMT+2
Sleep Timer Off
Auto Standby 4H
Sleep timer for OSD menu 30 S
Note:
7
Additional operations are explained in the
following sections.
Time
Current time and date information is retrieved
automatically from the broadcast.
Time Zone
1 Select »Time Zone« using » V « or » Λ « and
confirm with »OK«.
2 Select the time zone using »
V «, » Λ «, »
<
«
or »
>
« and confirm your selection with
»OK«.
3 Press »EXIT« to finish setting.
Sleep timer
You can enter an off time for the television to
switch off. After this time has elapsed, the televi-
sion switches to standby mode.
1 Select »Sleep Timer« using »
V « or » Λ «
and confirm with »OK«.
2 Select the sleep timer using »
V « or » Λ «
and confirm with »OK«.
Note:
7
Disable the function with » V « or » Λ « by
switching it to »Off« position.
3 Press »EXIT« to finish the setting.
Auto standby
This function will switch the television to stand-
by mode in 4 hours if the television does not
receive any picture signals for 5 minutes or ac-
cording to European regulations, if no key on
the keyboard of the TV or the remote control is
pressed.
1 Select »Auto Standby« using »
V « or » Λ «
and confirm with »OK«.
2 Select the sleep timer using »
V « or » Λ «
and confirm with »OK«.
Note:
7
You can disable the function with » V « or
»
Λ « by switching it to »Off« position.
3 Press »EXIT« to finish the setting.
Sleep timer for OSD menu
This function allows you to specify the time dur-
ing which the OSD menu will remain on the
screen.
1 Select »Sleep timer for OSD menu« using
»
V « or » Λ « and confirm with »OK«.
2 Select the sleep timer using »
V « or » Λ «
and confirm with »OK«.
3 Press »EXIT« to finish the setting.