Amano OPUS-7000 Series - Cash Check; Page Two; In Operation;Out of Service

To Next Page

To Previous Page

OPUS-7000 Series

Operations

Manual

Keypad:

Use the keypad to enter a new value. Use the red C to clear the value

and use the green E to accept the entered value.

Once the desired values are inserted, press the Set button in the lower-left

corner. After Set has been pressed, press OK to accept the changes. Press

Return when finished. Verify the settings have been saved by viewing the First

Time Operation menu. Verify the time is also correct on the Idle screen.

5.1.4 Cash Check

The Cash Check menu displays the current coin/note unit quantities. Press the

Cash Check to enter the menu. Press the Coin Unit Sub Total button to print out

the Coin Unit Sub Total Report via the receipt printer. The receipt shows detailed

information regarding coin denominations, received/dispensed quantities, and

previous coin/note quantities. Press Return when finished.

5.2 Page Two

• In Operation/Out of Service: Operational status of the Paystation.

• Opening Hours Start/End: Hours of operation.

• Shutter Control: How shutters are opened (always or triggered by

loops)

• Clear Password: Clear the management password

• To Engineer Operation: Navigate to the Engineer Operation menu

• To Operator Operation: Navigate to the Operator Operation menu

• To Manager Operation: Navigate to the Manager Operation menu

• Back to Idle: Return the Paystation back to normal operation.

5.2.1 In Operation/Out of Service

The OPUS-7000 series Paystation is able to run in one of three operation

modes. Open the In Operation/Out of Service mode by navigating to page two of

the First Time Operation menu and pressing In Operation/Out of Service.

Change the state of the Paystation by pressing the button labeled with the

desired operational state. In Operation will always keep the Paystation in

operation. Automatic will keep the Paystation in/out of operation using the

settings configured in the Opening Hours Start/End menu. Closed will put the

Paystation in a closed state, where it is not able to process transactions.

Other manuals for Amano OPUS-7000 Series