5 Installation at Site
28 of 124
Amarex KRT
Nominal flange
diameter
Forces [lbs] Moments [lbsft]
F
x
F
y
F
z
∑F M
x
M
y
M
z
∑M
500 3380 3041 3753 5889 10597 7517 8653 15620
600 4058 3651 4499 7065 14813 10560 12173 21927
700 4702 4318 5087 8275 18847 12613 15400 27353
Table13: Forces [N] and moments [Nm]
Nominal flange
diameter
Forces [N] Moments [Nm]
F
x
F
y
F
z
∑F M
x
M
y
M
z
∑M
200 6000 5400 6700 10450 3250 2300 2650 4800
250 7450 6750 8350 13050 4450 3150 3650 6550
350 10450 9400 11650 18250 7750 5500 6350 11400
400 11950 10750 13300 20850 9700 6900 7950 14300
500 14950 13450 16600 26050 14450 10250 11800 21300
600 17950 16150 19900 31250 20200 14400 16600 29900
700 20800 19100 22500 36600 25700 17200 21000 37300
5.3.1.3 Fitting the guide cable arrangement
The pump set is guided into the sump or tank along two parallel, tightly stretched
guide cables made of stainless steel. It attaches itself automatically to the base elbow
which has been fitted to the floor.
NOTE
Should site conditions/piping layout, etc., require the cable to run off the vertical,
do not exceed a maximum angle of 5° to ensure reliable fitting and guiding of the
pump set.
Fitting the mounting bracket
1. Use steel anchor bolts 90-3.37 to fasten mounting bracket 894 to the edge of
the sump opening.
2. Pre-assemble the clamping arrangement consisting of guide cable suspension
bracket 572, thrust insert 553 and hexagon head bolts 901.36.
3. Fasten fully threaded stud 904 with the pre-assembled clamping arrangement to
the mounting bracket with nut 920.36.
Do not tighten nut 920.36 too much in order to allow sufficient play for
subsequently tensioning the guide cable.
To Next Page