7 Servicing/Maintenance
72 of 124
Amarex KRT
7.3 Drainage/cleaning
WARNING
Fluids handled, consumables and operating supplies which are hot or pose a health
hazard
Hazard to persons and the environment!
▷ Collect and properly dispose of the flushing fluid and of any residues of the
fluid handled.
▷ Wear safety clothing and a protective mask if required.
▷ Observe all legal regulations on the disposal of fluids posing a health hazard.
1. Always flush the pump if it has been used for handling noxious, explosive, hot
or other hazardous fluids.
2. Always flush and clean the pump before transporting it to the workshop.
Always complete and enclose a certificate of decontamination when returning
the pump set. (ðSection10,Page118)
7.4 Dismantling the pump set
7.4.1 General information/Safety regulations
WARNING
Unqualified personnel performing work on the pump (set)
Risk of personal injury!
▷ Always have repair work and maintenance work performed by specially trained,
qualified personnel.
WARNING
Hot surface
Risk of personal injury!
▷ Allow the pump set to cool down to ambient temperature.
WARNING
Improper lifting/moving of heavy assemblies or components
Personal injury and damage to property!
▷ Use suitable transport devices, lifting equipment and lifting tackle to move
heavy assemblies or components.
Observe the general safety instructions and information.
For dismantling and reassembly observe the general assembly drawing.
In the event of damage you can always contact our service departments.
DANGER
Insufficient preparation of work on the pump (set)
Risk of personal injury!
▷ Properly shut down the pump set.
▷ Close the shut-off elements in the suction line and discharge line.
▷ Drain the pump and release the pump pressure.
▷ Shut off any auxiliary feed lines.
▷ Allow the pump set to cool down to ambient temperature.
To Next Page