To Next Page

To Previous Page

button, and CHANNEL/+ button.

3.1 Channel Selection

Press the CHANNEL/+ button to switch the display between the Channel 1 temperature, Channel 2

temperature, indoor temperature , remote sensors 3 through 8, and scroll mode . The channel

indication arrow will point at the selected channel. In scroll mode, the indoor temperature, and

Channels 3-8 will alternately be displayed in five second intervals.

3.2 Min and Max Alarm

You can set a min and max temperature alarm on the Channel 1 and Channel 2 thermometers. If the

alarm is exceeded for more than 10 minutes, as audible alert will occur and the alarm value will flash.

To silence the alarm, press any button.

To set the alarm, or adjust the min and max alarm settings, press the CHANNEL/+ button until the

channel indication arrow points at the selected channel.

3.2.1 Turning On and Off the Alarm

With the indicator arrow pointing at the appropriate channel, press the ALARM button to turn

on and off the alarm. The alarm icon will appear when set, and disappear when disabled.

The alarm will sound if the sensor falls bellow or rises above the MIN/MAX limit.

3.2.2 Setting the Min and Max Alarm

With the indicator arrow pointing at the appropriate channel, press and hold the ALARM button

for 3 seconds and the MAX alarm will flash. Press the CHANNEL/+ button to increase the MAX

alarm and the CLEAR/- button to decrease the MAX alarm. Press and hold the + or - button to change

rapidly.

Press the ALARM button again and the MIN alarm will flash. Press the CHANNEL/+ button to

increase the MIN alarm and the CLEAR/- button to decrease the MIN alarm. Press and hold the + or -

button to change rapidly.

When complete, press the ALARM button again, and the display will return to normal mode.

3.2.3 Viewing the Min and Max Alarms

With the indicator arrow pointing at the indoor temperature channel, press the ALARM

button to view the Channe1 and Channel 2 alarm limits.

3.3 Reset Max/Min

With the indicator arrow pointing at the appropriate channel, press and hold the CLEAR/-

button for 3 seconds to restore the MAX and MIN values to the current value.

3.4 Temperature Units of Measure

With the indicator arrow pointing at the indoor temperature channel, press and hold the

Ambient Weather WS-091-C User Manual

Questions and Answers: