www.amcelettronica.com 9
ARM/DISARM THE CONTROL PANEL VIA SMS
UPWD:(user code) ARM=T TOTAL ARMING
UPWD:(
user code) ARM=1 PARTIAL ARMING 1
UPWD:(
user code) ARM=12357 ARMING OF PARTIALS 1 - 2 - 3 - 5 - 7
UPWD:(
user code) DISARM=T TOTAL DISARMING
UPWD:(
user code) DISARM=2 DISARMING OF ONLY PARTIAL 2
UPWD:(
user code) DISARM=125 DISARMING OF PARTIALS 1 - 2 - 5
UPWD:(
user code) ARM? REQUEST THE ARMING STATUS OF THE CONTROL PANEL
ARM=0 DISARMED
ARM=T TOTAL ARMED
ARM=125 PARTIALS ARMED 1 - 2 - 5
Example of SMS composition in which partial 1 and 3 are to be activated:
UPWD:111111______ARM=13
List of commands for SMS composition:
Example:
UPWD:111111 OUT.3=1 (output 3 activation command)
N.B.: Remember to always insert a space after the password
spaceuser code
This is the complete list of all system programming/query commands.
LOCK=ON SYSTEM RELEASE COMMAND (to allow the installer to perform remote operations)
LOCK=OFF SYSTEM LOCK COMMAND (to inhibit the installer from remote operations)
OUT.x=1 OUTPUT ACTIVATION COMMAND (“x” corresponds to the output number)
OUT.x=0 OUTPUT DEACTIVATION COMMAND (“x” corresponds to the output number)
OUT.x? OUTPUT STATUS REQUEST (“x” corresponds to the output number)
IN.x? INPUT STATUS REQUEST (“x” corresponds to the input number)
SYSTEM MANAGEMENT VIA SMS
System management via SMS
The control panel can also be armed or disarmed by sending an SMS message as follows:
To Next Page
Loading...
Need help?
General