www.amcelettronica.com 14
ARM/DISARM CONTROL PANEL
System management from graphic keypad
During the programming phase, it is possible to activate the system without requiring any code (quick arm). This
possibility must be set by the installer.
Tapping on a group will arm the control panel. To activate the individual areas, it will be necessary to tap on one
of the area icons and a new screen will appear with the possibility of choosing the activation. Once the selection
has been made, confirm with the enter key.
By tapping to insert a group or area
that is not ready (orange), as soon
as the control panel is armed, it
will go into alarm. To view the non-
ready zones (detectors) belonging
to the group or area, click on the
icon in the bottom right.
A window will appear that allows
exclusion/inclusion of the individual
zones (detectors).
Once the selection has been made,
confirm with the enter key.
WHITE = Working
ORANGE = Not ready
GREY= Not enabled
Tapping the ARM/DISARM icon
on the home screen prompts the
entering of your code. Subsequently,
the keypad will show 4 activation
GROUPS (G1, G2, G3, G4) and the
AREAS (A1, A2, A3, A4, A5, A6,
A7, A8) belonging to the relative
groups.
To Next Page
Loading...
Need help?
General