Amcrest IP2M-851 - Page 92

92
• Relay Out: This checkbox allows the user to enable the camera to trigger a connected alarm (connected to
the alarm port on the back of the camera) when a relay activation alarm is triggered.
• Alarm Delay: This field specifies in seconds how long the delay between alarm activation and Relay alarm
activation should be.
• Send Email: This checkbox allows the user to enable the camera to send an email when an alarm is
activated.
• Snapshot: This checkbox allows the user to enable the camera to take a snapshot when an alarm is
activated.
To reset to default settings, click the Reset Defaults button. To refresh the page, click the Refresh button. To save
the settings, click the Save button.