EasyManua.ls Logo

AMD Xilinx ZCU670 - Page 47

AMD Xilinx ZCU670
94 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GTY SI570:
Programmable oscillator: Skyworks Soluons, Inc. (SiLabs) SI570BAB000544DG (10 MHz-810
MHz, 156.250 MHz default)
I2C 0x5D
LVDS dierenal output
Total stability: 61.5 ppm
The SI5341A and SI570 data sheets can be found on the Silicon Labs website.
User SMA Clocks
[Figure 2, callout 34]
The ZCU670 board provides four clock inputs using single-ended (J128, J146) and three pairs of
SMAs (J8/J98, J99/J100, J129, J143). This provides for single-ended 1588 eCPRI 1 PPS input
and an AC coupled user clock input. This also provides for dierenal user ADC, DAC, and AC
coupled 1588 eCPRI clock inputs.
The single-ended 1 PPS input from J128 is connected to Renesas (IDT) 8A34001 U409.J1. The
single-ended AC coupled user input connects to Skyworks Soluons, Inc. (SiLabs) SI5381A
U43.63 (IN0).
The ADC dierenal pair feeds into Zynq UltraScale+ RFSoC U1 ADC Bank 226. The P-side SMA
J8 signal ADC_CLK_226_P connects to U1.AB5. The N-side SMA J98 signal ADC_CLK_226_N
connects to U1.AB4. The DAC dierenal pair feeds into Zynq UltraScale+ RFSoC U1 ADC Bank
228. The P-side SMA J99 signal ADC_CLK_226_P connects to U1.J5. The N-side SMA J100
signal ADC_CLK_226_N connects to U1.J4 The dierenal 1588 eCPRI clock signal pair is series
capacitor coupled to the Skyworks Soluons, Inc. (SiLabs) SI5381A. The P-side SMA J129 signal
8A31004_CLK3_P connects to U409.E1 CLK3_P. The N-side SMA J143 signal
8A31004_CLK3_N connects to U409.E2 CLK3_N.
See Zynq UltraScale+ RFSoC Data Sheet: DC and AC Switching Characteriscs (DS926). The detailed
RFSoC connecons for the feature described in this secon are documented in the ZCU670
board XDC le, referenced in Appendix B: Xilinx Design Constraints.
zSFP/zSFP+ Module Connectors
[Figure 2, callout 15]
The ZCU670 board hosts a quad zSFP/zSFP+ connector (J29) that accept zSFP or zSFP+
modules. The connectors are housed within a single 2x2 zSFP cage assembly. The following
gure shows the zSFP/zSFP+ module locaons within J29.
Chapter 3: Board Component Descriptions
UG1532 (v1.0) March 30, 2022 www.xilinx.com
ZCU670 Board User Guide 47
Send Feedback

Related product manuals