Ameri-Shred 2 Series - Electrical Installation; Nameplate Reference

5
AMS-1000 Hard Drive Shredder Manual 2016 v.1
All electrical installaon and service must be accomplished by a qualied electrician. Follow all naonal and local
electrical codes and ordinances.
“WARNING”
LOCK POWER IN OFF POSITION
 All internal wiring has been factory installed and tested prior to shipping. Electrical installaon consists of
providing adequate machine power only.
 Check building service to ensure correct voltage is available and those current requirements can be met
(according to nameplate (serial number), see below).
 Install receptacle (provided) to properly protect building circuit. Select appropriate wire size and current
protecon to accommodate current requirements as shown on nameplate. Plug in power cable.
 Clear all personnel from machine area. Ensure machine is clean and no tools, rags, or debris have been le
on conveyor belt or near cuers or drive mechanism.
 Turn building service drop power on. Check voltage at installed receptacle.
 Ensure area is clear. Turn key switch ON. Jog reverse. Check for proper motor rotaon. If rotaon is wrong,
unplug power cable. Check that power is OFF with voltage meter at panel. Remove any two power wires
from the motor starter, reverse and reconnect.
 Clear area, turn on power and recheck rotaon.
 Electrical installaon is complete.
 Replace all guards.
ELECTRICAL INSTALLATION
NAMEPLATE:
Log your shredder specics here
MODEL NO. HP
PHASE SERIAL NUMBER
VOLTS CYCLE A.C. AMPS
JOB NUMBER