Ameri-Shred 2 Series - Start up Procedure

7
AMS-1000 Hard Drive Shredder Manual 2016 v.1
PRESTART UP PROCEDURE
 Familiarize yourself with all controls and buon locaons.
 Ensure that all guards and covers are in place.
 Ensure the area is clean.
 Check input area for debris, discarded tools, etc.
START UP PROCEDURE
START UP
Plug power cable into installed receptacle. Turn key switch ON. Momentarily depress the FORWARD
pushbuon. Cuers will begin to rotate and the output conveyor will begin to run forward.
To stop machine at any me depress the red STOP pushbuon. For emergency situaons the STOP pushbuon
may be depressed at any me. For normal stop situaons, wait for input chute to empty itself and the output
conveyor to discharge all shredded material before depressing STOP buon.
Begin feeding material to be shredded. It is recommended that during the familiarizing period the operator
should proceed with small amounts of media. Aer several hours experience the operator may wish to increase
the amount of material being fed. The operator will soon be able to judge the eciency of the operaon and
feed material accordingly. It is nearly inevitable that during this learning process the machine will jam. A jam
condion will automacally turn o the machine just as if the operator had depressed the STOP buon. This is
normal.
Shredder Control Panel
Le to Right - Emergency Stop - Forward - Reverse - On/O Key Switch - Power On Indicator Light
Figure 2