Intellex IP
68 Intellex®
6 The Discover AD Devices screen will be displayed. All AD devices within the same subnet as
the Intellix IP are discovered and displayed in the list. The list will include previously discovered
and configured devices.
Note
If the IP Encoder that is being added does not appear in the list, and is on the same subnet as
the Intellex, select Refresh. This will clear the list and rediscover the AD IP devices.
Note
If the IP Encoder has not been configured, highlight the IP Encoder and then select Device
Setup. A new browser window will open displaying the IP Encoder Main Configuration Page’
For more information on configuring the IP Encoder, see the IP Encoder Installation and User
Guide.
7 Highlight the IP Encoder and select Add. The Configure AD Device screen will be displayed.
8 Go to step 12
9 If the IP Encoder is on a different subnet it will not be detected by the discovery tool.
Select Skip Discovery.
The Configure AD Device screen will be displayed to allow manual configuration of network
information and video stream parameters,
If Then go to
the IP Encoder appears in the list
of discovered devices
step 7
the IP Encoder is on a different
subnet
step 9