EasyManua.ls Logo

American Eagle SHD-60 - User Manual

American Eagle SHD-60
30 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
7/<3-+8+16/8-
 %>+>/%><//>
"!9B
+<8/<

+B
AAA+7/<3-+8/+16/+---97
9./6(97:</==9<
9./6%'97:</==9<
9./6%97:</==9<
Manual Part No. 40984
Last Revision: 07/22/11
Subject to Change without Notification.
© 2011 American Eagle
Safety, Installation, Maintenance, and Operation
!) $F%  '

Table of Contents

Questions and Answers

  • C
    Claudia McguireAug 16, 2025
    What to do if my American Eagle SHD-60 Compressor does not run?
    • A
      Amanda KruegerAug 16, 2025
      If your American Eagle Compressor is not running, several factors could be at play. First, ensure the compressor is receiving 12-volt power by checking the fuse. Next, verify that the air reservoir isn't full; drain it and activate the pressure switch. Confirm that the hydraulic lines are properly connected. Check for any blockages in the couplers or hoses and remove any restrictions. If there's air load against the compressor, relieve the air pressure. Also, inspect the hydraulic pump and motor for proper functioning. Lastly, a leaking check valve could be the culprit, so disassemble, clean, and reinstall or replace it as necessary.
  • C
    Christopher SpencerAug 19, 2025
    Why is my American Eagle SHD-60 Compressor running hot?
    • J
      Jerry FinleyAug 19, 2025
      If your American Eagle Compressor runs hot, several issues could be responsible. Start by checking the compressor's rotation and inspect the fittings on the hydraulic motor. Next, examine the compressor reed valves; they may need cleaning or replacement. A dirty intake filter can also cause overheating, so clean the filter assembly. Ensure the oil level is adequate and add oil if needed. Finally, a leaking check valve can contribute to the problem; disassemble, clean, and reinstall it to resolve the issue.
  • N
    Nicholas TurnerAug 22, 2025
    Why is the air output too low on my American Eagle SHD-60 Compressor, but the air pressure is okay?
    • A
      Ashley EllisonAug 22, 2025
      If the air output from your American Eagle Compressor is low, but the air pressure is okay, consider these potential causes: The compressor speed might be too low, so refer to the troubleshooting steps for a slow-running compressor. The air filter could be dirty, requiring cleaning or replacement. Leaking airlines can also reduce output, so retighten the hoses. Lastly, a plugged check valve can restrict airflow; remove and clean it.
  • J
    Jessica Williams DDSAug 25, 2025
    Why is my American Eagle SHD-60 running too slow?
    • M
      martintaraAug 26, 2025
      If your American Eagle Compressor is running too slow, several factors could be responsible. Inspect, clean, or replace the compressor reed valves. Tighten any leaking hose fittings. Check and reset the hydraulic flow if it's too low. A worn hydraulic motor can also cause this issue, so consider replacing it. Readjust the relief valve if the power unit relief is set too low. If the hydraulic system is too hot, your reservoir might be too small, so add a cooler to the system. Lastly, check the power supply and readjust it if the speed control isn't working.
  • L
    Lisa SotoAug 27, 2025
    Why is the air output low and air pressure low on my American Eagle Compressor?
    • Y
      Yvette MillerAug 27, 2025
      If the air output from your American Eagle Compressor is low and the air pressure is also low, start by inspecting and cleaning the air filter. If air back-flows from the air filter, the intake reed valve is likely faulty and needs replacement. Also, ensure that the head bolts have sufficient torque and tighten them to the required torque if necessary.
  • R
    Rebekah TaylorAug 30, 2025
    What to do if my American Eagle SHD-60 Compressor will not stop?
    • J
      jay27Aug 30, 2025
      If your American Eagle Compressor will not stop, the issue might stem from an incorrectly set air pressure switch; check its points and settings. Alternatively, leaking hoses or fittings could be the cause; tighten all fittings and hoses to resolve this.
  • J
    Jessica RiveraSep 2, 2025
    Why does my American Eagle Compressor keep cycling when air is not being used?
    • G
      gallagherbrittanySep 2, 2025
      If your American Eagle Compressor cycles frequently, even when air isn't being used, there are a few potential causes. Leaks in the airline could be responsible, so tighten the hoses and fittings. Alternatively, the air pressure switch might be set incorrectly; check the cut-in and cutout settings. Finally, dirt in the solenoid valve could be causing the cycling; remove and clean it.
  • B
    baileyanitaSep 4, 2025
    How to fix low air pressure on my American Eagle Compressor?
    • C
      Cindy Ward PhDSep 4, 2025
      If the air pressure from your American Eagle Compressor is too low, start by readjusting the high-pressure setting on the air pressure switch. Inspect the air line for leaks and tighten any loose hoses. Check whether the air demand from connected items exceeds the compressor's capacity. Finally, inspect the intake or exhaust valves for damage and replace them if necessary.
  • A
    Alex LloydSep 7, 2025
    What causes air pressure to be too high on an American Eagle Compressor?
    • Z
      zoe26Sep 7, 2025
      If the air pressure from your American Eagle Compressor is too high, first inspect and clean the pressure switch, as internal contamination may be the cause. If the pressure switch is not operating correctly, inspect and clean it. If the issue persists, readjust the pressure switch to a lower pressure setting.
  • B
    Benjamin JonesSep 10, 2025
    What causes high crankcase oil usage in my American Eagle Compressor?
    • B
      brian41Sep 10, 2025
      If your American Eagle Compressor has high crankcase oil usage, check the oil level and drain if needed. Inspect gaskets or seals for oil leaks and repair them. If the problem persists, the piston rings may be worn or broken, requiring replacement.

Summary

Class 4 Compressor Manual Revisions

Introduction

Safety

Precautions

Essential safety measures and personal protective equipment guidelines.

Specifications

Compressor System Description

Details of the internal components and build of the compressor.

SHD-60 Drive System Description

Specifics of the drive system for the SHD-60 model.

General Specifications

Key technical data, model numbers, and dimensions.

Operation

General Operation Notes

Standard procedures for starting and operating the compressor unit.

SHD-60 Operation Notes

Specific operational guidance and settings for the SHD-60 model.

Maintenance

Installation

Compressor Installation

General instructions for installing compressor components and assemblies.

SHD-60 Installation

Specific installation procedures for the SHD-60 compressor model.

Pressure Setting Instructions

Guide for adjusting pressure switch settings for optimal operation.

Assembly Drawings

Crankcase Group (Tapered Shaft)

Exploded view and parts list for the tapered shaft crankcase assembly.

Crankcase Group (Straight Shaft)

Exploded view and parts list for the straight shaft crankcase assembly.

Cylinder Group

Exploded view and parts list for the cylinder assembly.

Head Group

Exploded view and parts list for the cylinder head assembly.

Manifold Discharge

Exploded view and parts for the manifold discharge.

Head Options

Overview of different head configurations available for the compressor.

Optional Head Unloader

Exploded view and parts for the optional head unloader mechanism.

Flywheel Options

Details on the available flywheel sizes and groove configurations.

Clutch Options

Overview of different clutch types and specifications.

SUH-60 Compressor Assembly

Exploded view and parts list for the SUH-60 compressor assembly.

SHD-60 Compressor Assembly

Exploded view and parts list for the SHD-60 compressor assembly.

Hydraulics;Electrical

SHD-60 Control Kit

Diagram and part list for the SHD-60 electrical control system.

Typical Hydraulic Circuit for Single Stage Pump with Multiple Components

Schematic of a hydraulic circuit for a single-stage pump system.

Typical Hydraulic Circuit for Tandum (Two Part) Pump with Multiple Components

Schematic of a hydraulic circuit for a tandem pump system.

Typical Hydraulic Circuit for Compressor with Auxiliary Cooler

Schematic of a hydraulic circuit incorporating an auxiliary cooler.

Replacement Parts

Troubleshooting

General Troubleshooting

Common issues and their solutions applicable across compressor models.

SHD-60 Troubleshooting

Specific troubleshooting guidance for the SHD-60 compressor.

Limited Warranty Statement

American Eagle SHD-60 Specifications

General IconGeneral
ModelSHD-60
Horsepower5 HP
Max Pressure175 PSI
Voltage230V
CategoryCompressor
Tank Capacity60 Gallon
PhaseSingle

Related product manuals