American Standard Selectronic - Metering Faucet Mode Settings; Metering Run Time Configuration

7
MENU 4.2
METERING
From MENU 4.1
COMF. TIMEOUT
= 15 Sec
Press up or down to adjust
metering run time
Auto. RINSE
= OFF
Auto. RINSE
= 15 s
Press up or down to turn ON
the Auto Rise feature and
adjust frequency
Align the programmer with the sensor
and press to transmit the program, with
the Auto Rinse OFF, to the sensor
Press up or down to adjust time
Align the programmer with the sensor
and press to transmit the program, with
the Auto Rinse ON, to the sensor
To MENU 4.3
¾ Metering -- Faucet
TIP: In this Metering Mode, the “COMF. TIMEOUT”
(Comfort Timeout) is the RUN TIME - how long the water
will run once activated by the user.
• Run Times: 1, 2, 3.25, 7.5, 10, 15, 30, 60, or 120
seconds
(RUN TIME)
Setting the sensor to the Metering faucet mode:
- Set the "Comfort Timeout" (run time)
-Set "Auto-Rinse" frequency (if the frequency is set to 0,
‘auto-rinsing” (auto-purging) is Off)
- Set the "Duration" (run time) of the auto-rinsing process.
TIP: The “Auto. RINSE” (Auto Purge) allows the faucet
to automatically
turn ON after a set time period of non
use, maintaining the trap seal & preventing the water
from becoming stagnant
Default Setting: ‘OFF’
• This time period can be set to activate from 1 to 72
hrs (of non-use) in 1 hr increments.
• The duration of run time can be set from 1 sec. to 240
sec.