ALS-600 SPECIFICATIONS
Output Power: 600 Watts PEP SSB, 500 Watts CW typical
Frequency Coverage: 1.5 to 22 MHz (10/12 Meters with MOD-10MB)
Driving Power Required: 100 watts maximum
Input SWR: 1.5:1 maximum
Spurious Outputs: Greater than 45 dB down
Intermodulation Distortion: Greater than 25 dB down
SWR Protection: Amplifier is bypassed if reflected power exceeds 75
watts. Prevents amplifier damage if you select the
wrong band or wrong antenna, or have high SWR
Over Power Protection: If output forward power or reflected power exceeds
safe level, output power is automatically reduced by
controlling the exciter ALC.
Metering (ALS-600): Illuminated Cross-Needle SWR/Wattmeter -- lets you
read SWR, and forward and reflected peak power
simultaneously
Metering (Power Supply): Illuminated Cross-Needle Meter monitors voltage and
current of 50 VDC line.
Operate/Standby Switch: Lets you run "barefoot", or instantly switch to full
power.
ALC Controls: Front Panel - exclusive Ameritron feature -- lets you
adjust your amplifier output power.
Rear Panel – sets ALC range to match your
transceiver.
T/R Relay Drive Rqmts: Must support 12VDC at 100ma maximum, ground to
enable
Indicators: Transmit, ALC and Load Fault LED indicators to keep
you informed.
Accessory Power: Rear panel 12 VDC/200 ma RCA-type output jack for
powering low current accessories.
4
To Next Page
Loading...
