Readings View
This section includes the sequential number of each reading, The Date/ Time of each
reading, The Diameter of the impressions measured, HBW readings, Status – Pass / Fail,
and notes and Part Data information section. Readings will be shown in Green, Red or Yellow
depending on their tolerance status. Additional information can be added to the Note column
after measurements are completed. Click in box were information is to be added and type in
notes. Clicking on the Blue Arrow box reverses the order of the readings
XBar/RChart
This is a running chart of the readings on an XBar/RChart, Again, readings will be shown in
Green, Red or Yellow depending on their tolerance status. Control Limits are calculated by
the BOSS software, not user selected. By clicking on any reading on this chart or the
Readings View, that reading will be flagged in the other chart.
To Next Page
Loading...
