Ametek Newage USB Lab B.O.S.S. - Appendix C: B.o.s.s. Tether Option

B.O.S.S.
(R)
Operation Instructions
18
3.3 APPENDIX C: B.O.S.S. TETHER OPTION
Read the tether manufacturer directions to set up the tether.
To install the BOSS scan head on the tether, unscrew the nut holding the cable to the scan head. Attach the clip from the
cable over the cord between the scan head and the nut (See photo #1 below). Push the clip up against the scan head
and reattach the nut to full tightness (See photo #2 below).
Attach the tether coil clip to the tether arm. Follow manufacturer directions for any tether adjustments.
Model appearance may differ than shown
Other tether options are available as well.