Ametek Sorensen XG 80-10.5 User Manual

PROGRAMMABLE POWER
M370430-01 Rev F www.programmablepower.com
XG Family Programmable DC
Power Supply
Operating Manual
(firmware v 2.0 and higher)
670 Watts – 1700 Watts
Half Rack
Full Rack
6 V to 600 V Models:
6-110
6-220
6-220
8-100
8-187.5
8-200
12-70
12.5-120
12-140
20-42
20-76
20-84
33-25
30-50
33-50
40-21
40-38
40-42
60-14
60-25
60-28
80-10.5
80-19
80-21
100-8.5
100-15
100-17
150-5.6
150-10
150-11.2
300-2.8
300-5
300-5.6
600-1.4
600-2.6
600-2.8

Ametek Sorensen XG 80-10.5 Specifications

General

Brand	Ametek
Model	Sorensen XG 80-10.5
Category	Power Supply
Language	English

Summary

Installation Procedures

Connecting AC Input Power

Details the procedure for connecting the AC input power, including safety precautions and connector information.

Performing Functional Tests

Describes the procedures for performing power-on checks and verifying voltage and current mode operation.

Local Operation

Alarms and Errors

Covers various alarm conditions, their precedence, and how they affect the power supply's operation.

Using Over Voltage Protection (OVP)

Explains the OVP circuit's function, how to set trip points, and potential setup conflicts.

Resetting the Power Supply

Details the procedure for performing a soft reset to restore factory default settings, excluding calibration data.

Analog Programming (APG) and Isolated Analog Programming (ISOL)

Remote Operation

Hardware and Connection Setup

Information on setting up connections for RS-232, RS-485, USB, and GPIB interfaces.

Configuring Remote Control Using RS-232

Details the steps for setting up remote control via the RS-232 serial interface, including cable specifications.

Configuring Remote Control using the USB Connector

Guides on setting up remote control via USB, including driver installation and port verification.

Reset Command

Explains the device reset command and its effects on various functions and states.

Communications Options

SETTING UP LAN/ETHERNET

Provides information for network administrators on configuring and maintaining LAN/Ethernet connections for MEB option.

SETTING LAN PARAMETERS

Calibration and Troubleshooting

Calibrating the Output Voltage

Calibrating the Output Current

APPENDIX B Error Messages

APPENDIX C Specifications

Electrical Specifications for XG Family, 850 W

Electrical Specifications for XG Family, 1500 W

Electrical Specifications for XG Family, 1700 W

APPENDIX D Rack Mount Options and Installation Instructions

APPENDIX E Lantronix Procedures for MEA Option

Configuring the Device Using DeviceInstaller

Assigning an IP Address to the Power Supply Unit