Ametek SPECTRO ARCOS FHX22 - Page 34

Maintenance
—
34 SPECTRO ARCOS FHX22 —
18.07.2019
 Plasma torch for axial plasma observation:
I. Push the plasma torch (3)
through the torch support
(1). When inserting it into
the bayonet fastener (2),
pay attention to the position
of the marker point (4).
II. Turn the plasma torch a
little in clockwise direction
until the bayonet fastener
engages (5).

The plasma torch is
adjusted correctly
when the gap between
the center tube of the
plasma torch (7) and
the right end of the
load coil (6) is 1 to 3
mm.
Fig. 11
 Plasma torch for radial plasma observation:
I. The installation procedure
is identical to the one used
for installing the EOP. Only
the position is different.

The plasma torch has been
cleaned.
Fig. 12
1
2
3
4
5
1–3 mm
6
7