45/69 Cal_h10 Auto calibration hour value R/W
46/70 Cal_h1 Auto calibration hour value R/W
47/71 Cal_m10 Auto calibration minute value R/W
48/72 Cal_m1 Auto calibration minute value R/W
49/73 Ver_h10 Auto verify time hour value R/W
4A/74 Ver_h1 Auto verify time hour value R/W
4B/75 Ver_m10 Auto verify time minute value R/W
4C/76 Ver_m1 Auto verify time minute value R/W
4D/77 Pressure Process pressure. R/W
4E/78 Optemp The cell temperature setpoint Read only
4F/79 Optemp_range Operating temperature for sensor, 0 is
normal, 1 is high, 2 is RM CEM
IQ
R/W
50/80 Cmbref Reference voltage reading for Combustibles
channel
Read only
51/81 Cmbact Active voltage reading for Combustibles
channel
Read only
52/82 Cmbgnd Ground reading for Combustibles channel Read only
53/83 Mthref Reference voltage reading for the Methane
channel.
Read only
54/84 Mthact Active voltage reading for Methane channel Read only
55/85 Mthgnd Ground reading for Methane channel Read only
56/86 AT Cell slope Read only
57/87 AT_ratio Cell slope used during last calibration. Read only
58/88 Tc_ratio Cell/thermocouple compensation multiplier Read only
59/89 Cmbslope Combustibles slope during last calibration Read only
5A/90 Mthslope Methane slope during last calibration Read only
5B/91 Cal_cycle Interval between auto cals [1 hour to 90
days]
R/W
5C/92 Ver_cycle Interval between auto verifies [1 hour to
90 days]
R/W
To Next Page
Loading...
