Controller / User Interface | 4-3
Automatic Menu Exit Feature
If you don’t press a key after 15 minutes, the system exits the menu you were
in and returns the system to normal operations (exits out of all menus).
On-Line Help
Press the Help key to get a description of the function for the menu options.
Press Help again to exit on-line help and return to the menu options (or press
the Cancel or Enter). For example, to get on-line help for the Passwords op-
tion from the Setup key, select the Setup key, then move the arrow pointers
to Passwords and press Help.
System Password
By default, the system password is disabled. If you don’t want to
enable a system password, you can skip this section. You can also use
this menu option to disable the password requirement.
Setting up a system password
If you have forgotten the correct password, you can call AMETEK/
Thermox and a service password will be provided so that you can ac-
cess the Password option and enter a new system password.
1. From the menu key menu, select Passwords.
You will be prompted to enter a new system password:
Enter NEW Password
2. Enter a four-digit password. You are prompted to reenter the pass-
word to verify it.
Reenter to Verify
3. Reenter the password.
To later disable or change the system password, you must first enter
the old password to access this menu option, then change or disable
the password (0000 disables the password).
To Next Page
Loading...
Need help?
General
