4-20 | Thermox Series 2000 WDG-IV / IVC / IVCM
Alarm Key
Alarm Set Points
Alarm Configure
Relay Configure
Select Function
Exception Log
Figure 4-4. Alarm Key menu.
Alarms 1 and 2 are hard wired for the Watchdog Timer and Service
alarms and are not software-selectable.
Oxygen, combustibles, and methane alarms are all disabled during a
primary or regular calibration. In addition, alarms are disabled dur-
ing start-up until the sensor reaches its proper operating temperature.
See the “Wiring” section in the Installation chapter for help on alarm con-
nections and how alarms are labeled on the control unit wiring card.
To Next Page
Loading...
Need help?
General
