APPROVED FOR EXTERNAL DISTRIBUTION
– PROPERTY OF AMPCONTROL PTY LTD
– NOT TO BE REPRODUCED IN PART
4.2 Mandatory Installation Practices
The following information must be adhered to when installing the OCS. Failure to adhere to this
information may give rise to unsafe operation.
Using the OCS in a manner that exceeds its electrical, functional or physical specifications, or in a way
that is contrary to its operating restrictions, may create risks to personnel and/or equipment resulting in
injury or death.
The OCS is to be installed in an electrical system having a fault level equal to or less than as
marked on the name plate.
The OCS’s control supply must remain within the specified voltage range.
The installation of the OCS must be carried out by suitably trained and qualified personnel.
Identification labels fixed to the OCS must not be damaged, removed or covered.
The installation is to be in accordance with the relevant installation Standards/Codes of Practice.
Modifications must not be made to any part of the OCS. As supplied, the unit is built to, and
complies with the relevant standards. Modifications to its construction will render the unit non-
compliant.
Complete and accurate records of the installation must be kept as part of the site installation.
The equipment is to be maintained as per the conditions as listed in the certification
documentation.
If the OCS is to be used in a hazardous environment, it must be
installed within suitably certified flameproof enclosure.
To Next Page
Loading...