Page 4 OM006-12 Model 116 Operating Manual
voltage of the batteries is too low to operate the instrument, the message
“Replace Battery” will appear. Note that local regulations are likely to
cover disposal of used batteries.
Mains operation
All other connections must be made before connecting the output lead
from the adapter into the POWER input socket on the back of the
audiometer. Switch on the mains supply - the indicator on the adapter and
the POWER indicator on the audiometer will both illuminate green,
showing that the instrument is ready for use.
The output from mains adapter is fitted with electronic circuit protection. In
case of overload the adapter will shut down and the indicator will be
extinguished. When the fault is cleared the adapter will operate as normal.
The input to the mains adapter is protected with a non-replaceable fuse. If
this fails the adapter will not operate.
The mains adapter is the mains disconnect device and therefore the
audiometer should be positioned such that easy access to the mains
adapter is possible.
If a replacement mains adapter is required, please contact Amplivox or
your Amplivox distributor.
2.4 Audiometer connections
All the relevant accessory terminals and connections are labelled to
ensure correct identification and connection as follows:-
To Next Page
Loading...
Need help?
General
