Amprobe AT-2032 - Error Detection for a Electrical Floor Heating

24
Error detection for a electrical floor heating.
Example 9 (single-pole application)
NOTE:
By touching the contact electrode „7“ the sensitivity range is increased to factor 1.5.
Note:
If a shield mat or shield wiring is located above the heating wires, no ground connection ( )
may exist. If required, separate the shield from the ground connection.
Please also note the connection conditions as mentioned in example 8.
LEVEL
I
I
I
SIG
N
A
L
L
EV
EL
CO
D
E
S
I
GNAL
LE
V
E
L
C
ODE
L
EVEL
I
I
I
PAEDAT203200:Layout 1 15.01.2009 15:04 Uhr Seite 24