AMX Modero ViewPoint MVP-8400 - ?Phn-Privacy; Phn-Setup-Domain; Phn-Setup-Enable; Phn-Setup-Password

Programming
171
MVP-7500/8400 Modero Viewpoint Wireless Touch Panels
The following table lists and describes SIP setup commands. Using any of these commands causes the
current user to go offline.
SIP Commands (Cont.)
^PHN-REDIAL
Redials the last
number.
Syntax:
"’^PHN-REDIAL’"
Example:
SEND_COMMAND Panel,"'^PHN-REDIAL'"
^PHN-
TRANSFER
Transfers the call
to the provided
number.
Syntax:
"’^PHN-TRANSFER, <connection id>, <number>’"
Variable:
connection id = The identifying number of the connection
number = The number to which you want to transfer the call.
Example:
SEND_COMMAND Panel,"'^PHN-TRANSFER, 1, 2125551000'"
SIP Setup Commands
^PHN-SETUP-
DOMAIN
Sets the realm for
authentication.
Syntax:
"’^PHN-SETUP-DOMAIN, <domain>’"
Variable:
domain = The realm used for authentication
Example:
SEND_COMMAND Panel,"’^PHN-SETUP-DOMAIN, asterisk’"
^PHN-SETUP-
ENABLE
Registers a new
user
Once the configuration has been updated, the ENABLE command should be run to
re-register the new user.
Syntax:
"’^PHN-SETUP-ENABLE’"
^PHN-SETUP-
PAS SWOR D
Sets the user
password for the
proxy server.
Syntax:
"’^PHN-SETUP-PASSWORD, <password>’"
Variable:
password = The password for the user name
Example:
SEND_COMMAND Panel,"’^PHN-SETUP-PASSWORD, 6003’"
^PHN-SETUP-
PORT
Sets the port num-
ber for the proxy
server.
Syntax:
"’^PHN-SETUP-PORT, <port>’"
Variable:
port = The port for the proxy server
Example:
SEND_COMMAND Panel,"’^PHN-SETUP-PORT, 5060’"
^PHN-SETUP-
PROXYADDR
Sets the IP
address for the
proxy server.
Syntax:
"’^PHN-SETUP-PROXYADDR, <IP>’"
Variable:
IP = The IP address for the proxy server
Example:
SEND_COMMAND Panel,"’^PHN-SETUP-PROXYADDR, 192.168.223.111’"